Vasodilating stents, “labs-on-chips” for analysis on smallest areas, 3-D cell culturing systems for tissue reconstruction: microtechnology is gaining importance in the medical sector. It also opens up new potentials in the area of implantology. Scientists of Karlsruhe Institute of Technology (KIT), together with experts for dental implants, have now developed a nanostructured surface to accelerate wound healing after implantation and to better protect it against the attack of bacteria.
“Microtechnology can sustainably improve dental implants,” says Professor Andreas Guber, who with Dr. Ralf Ahrens, heads the Biomedical Microtechnology (BioMEMS) research group at KIT’s Institute of Microstructure Technology. Modern dental implants consist of a titanium screw that is fixed in the jawbone to replace the dental root, a connected abutment made of titanium for tooth replacement, and the visible dental crown. Titanium is the material of choice. It is biocompatible and ensures good growth of the screw into the bone, which is also called osseointegration. So far, optimization of dental implants has focused mainly on the titanium surface of the screw in order to further improve this process. However, dental implants may become inflamed even after successful osseointegration.
The main gateway for bacteria is the abutment. If the gum is not in perfect contact with the abutment, pockets may form, via which bacteria can reach the jawbone and cause inflammation there. In this case, the complete implant has to be removed again. The BioMEMS team now wants to solve this problem. Research is based on an optimized abutment developed by the specialist “Abutments4Life.” Grooves smaller than the width of a hair circulate the abutment and guide the cells responsible for wound healing into the right direction. In this way, wound healing is accelerated. “This system is our point of departure,” Patrick Doll, scientist of IMT, says. Further development focuses on two aspects: more precise structuring of the grooves for better guiding of the cells and search for an optimum nanosurface to which the bacteria cannot attach.
With an electron-beam lithography system, Doll produced columnar structures of 100 nanometers in diameter and 500 nanometers in height. These structures were then used to carry out adhesion experiments with typical test bacteria, such as S. aureus, E. coli or P. aeruginosa. Moreover, the structures were varied constantly. The result: depending on the distance and arrangement of the columns, adhesion of bacteria is reduced and formation of a biofilm is delayed. Hence, recovering cells have more time to close the wound, an effect that would otherwise be achieved by antibiotics only.
Source: Read Full Article